Table of Contents
Advertisement
STEP 9 – SLIDE DISHWASHER PARTIALLY INTO
OPENING
Do not use dishwasher until completely installed.
Do not push down on open door.
Failure to follow these instructions can result in serious injury or cuts.
1. Slide dishwasher into the opening a few inches at a time.
NOTE: Do not push against the front of the panel or on the console – they will
dent.
2. Position power supply.
•
If dishwasher has a power supply cord, insert power supply cord into the hole
cut into the cabinet.
•
If using a direct-wire connection, check that the wiring is on the right front
side of opening.
3. Slowly move dishwasher completely into cabinet opening. As you proceed,
pull the drain hose through the opening under the sink. Stop pushing when the
dishwasher is a few inches forward of the adjacent cabinetry.
4. Make sure the drain hose is not kinked under the dishwasher and there is no
interference with the water line and wiring or any other component.
STEP 10 – POSITION DISHWASHER UNDER
COUNTERTOP
1. Push dishwasher completely into the opening so that the front corners of the
dishwasher door are flush with the cabinet doors.
NOTE: It is all right if the dishwasher fits tightly into cabinet opening. Do not remove
insulation blanket – the blanket reduces the sound travel.
Reposition dishwasher by grasping
both sides with hands.
WARNING
Tip Over Hazard
Do not push against front door panel
with knee. Damage to the door panel
will occur.
21
Advertisement
Table of Contents
