Table of Contents
Advertisement
Option 2 – (No Garbage Disposal- With Air Gap):
1. Cut end of drain hose if needed (do not cut ribbed section).
2. Attach drain hose to air gap with large spring-type clamp. If the drain hose was
cut, use a 11/2" to 2" (3.8 to 5 cm) screw-type clamp*.
3. Use a rubber hose connector* with spring or screw type clamps* to connect air
gap to garbage disposal inlet.
This connection must be before the drain trap and at least 20" (50.8 cm) above the
floor where dishwasher will be installed.
a
h
*Parts available from local plumbing supply store.
Option 3 – (Garbage Disposal - No Air Gap):
1. Remove the garbage disposal knockout plug. Do not cut end of drain hose.
2. Attach drain hose to garbage disposal inlet with screw-type clamp.
3. Use a rubber hose connector* with screw-type clamps* to connect garbage
disposal inlet.
This connection must be before the drain trap and at least 20" (50.8 cm) above the
floor where dishwasher will be installed. It is recommended that the drain hose
be looped up and securely fastened to the underside of the counter. "See "Drain
Requirements."
d
* Parts available from local plumbing supply store.
b
f
g
b a
c
a
Drain Hose - Cut Here if
Needed
b
Screw-Type Clamps
c
c
Air Gap
d
Screw-Type Clamp
d
e
Drain Hose
f
Rubber Hose Connector
e
g
Waste Tee
h
Drain Trap
a
Drain Hose
b
Screw-Type Clamp
c
Garbage Disposal Inlet
d
Drain Trap
15
Advertisement
Table of Contents
