Step 4- Install 90° Elbow; Step 5A- Prepare Cabinet Opening Using Existing Utility Hookups - Haier HDBL655AFS Installation Instructions Manual

STEP 4- INSTALL 90° ELBOW
Use two or more people to move and install dishwasher.
Failure to do so can result in back or other injury.
1. Using two or more people stand the dishwasher upright, and position it in front
of the opening.
2. Wrap the 90° elbow with thread seal tape, and then install it onto the water valve.
NOTE: To avoid damage to the water valve bracket and/or fitting, do not over
tighten the elbow.
3. Position the end of the elbow to face the bottom right of the dishwasher.
STEP 5A- PREPARE CABINET OPENING USING
EXISTING UTILITY HOOKUPS
•
Follow the steps in this section if you are installing the dishwasher in an existing
cabinet opening with utility hookups.
•
If you are installing the dishwasher in a cabinet opening that does not have
hookups, follow the instructions under "Prepare Cabinet Opening Where there
are No Existing Utility Hookups" in Step 5B.
1. Check that the water line reaches to the front left of opening where the water
connection will be made.
2. Check that the direct wire reaches to the front right of opening where the
electrical connection will be made.
If the water line and the direct wire reach far enough
into the opening, proceed to the next section
"Install the drain hose." If they do not reach far
enough, follow the instructions under "Prepare
Cabinet Opening Where there are No Existing Utility
Hookups" in Step 5B.
WARNING
Excessive Weight Hazard
water
direct
line
wire
6" (15.2 cm)
13