Table of Contents
Advertisement
NOTES:
•
Use UL listed wire nuts of the appropriate size to connect
the power cord to 16-gauge dishwasher wiring.
•
Insert wire ends into twist on connector. Do not pre-twist
bare wire.
•
Twist connector.
•
Gently tug on wires to be sure both wires are secured.
a
7. Tighten strain relief screws to secure cord.
8. Reinstall terminal box cover with wires inside terminal box.
9. Make sure wires are not pinched by cover.
STEP 12 - CONNECT TO WATER SUPPLY
Compression fittings:
•
Slide nut onto copper tubing about 1" (2.5 cm).
•
Slide ferrule onto the tubing. Do not position ferrule on the end of the
tubing.
•
Put the tubing into the elbow as far as it will go.
•
Slide the nut and ferrule forward and start the nut onto the elbow threads. Be
gentle when handling and positioning the copper tubing, it bends and kinks
easily.
1. Route the water supply line so that it does not touch the dishwasher base,
frame, or motor to minimize the noise caused by vibration when using the
dishwasher.
26
b
c
a
b
a
b
c
a
Elbow
b
Compression Nut
Ground
White
Black
Advertisement
Table of Contents
