Location Requirements - Haier HDBL655AFS Installation Instructions Manual

24" built-in dishwasher
Hide thumbs Also See for HDBL655AFS:
Table of Contents

Advertisement

LOCATION REQUIREMENTS

IMPORTANT:
Do not run drain lines, water lines or electrical wiring where they can interfere
with or contact dishwasher motors or legs.
The location where the dishwasher will be installed must provide clearance
between motors and flooring. Motors should not touch the floor.
The opening must have a level floor. (If floor at front of opening is not level with
floor at rear of opening, shims may be needed to level dishwasher).
Do not install dishwasher over carpeted flooring.
The dishwasher must be fully enclosed on the top, sides and back and must not
support any part of the enclosure.
The dishwasher must be installed so that the drain hose is no more than 10 ft in
length for proper drainage.
OPENING DIMENSIONS
The rough cabinet opening must be at least 24" (61 cm) deep and a maximum of
35" (88.9 cm) in height, and provide easy access to water, electricity and drain.
Corner locations require a 2" (5.1 cm) minimum clearance between the side of
the dishwasher door and the wall or cabinet.
* Make sure water line, wires and drain hose are within the shaded area.
** Min. to Max. distance from the underside of countertop to floor.
NOTE: ADA installation, 321/2" (82.5) cm beneath 34" (86.4 cm) high countertops
may be accomplished by adjusting the toekick and leveling legs.
90°
34" to 35"
(86.4 cm
to 88.9 cm)**
6"
(7.6 cm)
(15.2 cm)
1¾"
(4.4 cm)
24"
90°
3"
18"
(45.7 cm)
3"
(7.6 cm)
3"
(7.6 cm)
(61.0 cm)
5

Advertisement

Table of Contents
loading

This manual is also suitable for:

Hdbl655afwHdbl655afb

Table of Contents