Cmos Clear; Watch Dog Enable/Disable - Supermicro X10DRH-CLN4 User Manual

X10DRH-CLN4/iLN4 Motherboard User's Manual

CMOS Clear

JBT1 is used to clear the CMOS. Instead of pins, this "jumper" consists of contact
pads to prevent accidental clearing of the CMOS. To clear the CMOS, use a metal
object such as a small screwdriver to touch both pads at the same time to short
the connection.
Note: Be sure to completely shut down the system, and then short JBT1
to clear the CMOS.

Watch Dog Enable/Disable

The Watch Dog (JWD1) is a system monitor
that will reboot the system when a software
application hangs. Close pins 1-2 to reset
the system if an application hangs. Close
pins 2-3 to generate a non-maskable inter-
rupt signal for the application that hangs.
See the table on the right for jumper set-
tings. The Watch Dog must also be enabled
in the BIOS.
BMC
LAN CTRL
IPMI CODE
SAS CODE
MAC CODE
BAR CODE
BIOS
LICENSE
q
BIOS
PCH
A
JPS1
JBT1
LSI 3008
SAS CTRL
BT1
SAS4-7 SAS0-3
S-SATA(0-3)
Battery
SP1
B
LAN2/4 LAN1/3 USB0/1
UID
VGA
FAN6
USB4/5
(3.0)
FAN5
CPU2
Close First
Open First
X10DRH-CLN4/iLN4
Rev. 1.01
CPU1
Close First
Open First
2-34
Watch Dog
Jumper Settings
Jumper Setting Definition
Pins 1-2 Reset (default)
Pins 2-3 NMI
Open Disabled
A. Clear CMOS
COM1
B. Watch Dog Enable
JF1
JF2