Supermicro X10DRH-CLN4 User Manual page 13

Jumper Description
JBT1 Clear CMOS/Reset BIOS Configuration
JPB1 BMC Enable
JPG1 VGA Enable
JPL1 GLAN1/2/3/4 Enable
JPME2 Manufacture (ME) Mode Select
JPS1 SAS Enable (X10DRH-CLN4 only)
JWD1 Watch Dog Timer Enable
Connectors
BT1 (Battery)
COM1/COM2
FAN1-6, A, B
J24
JD1
JF1
JF2
JIPMB1
JL1
JNVI C1/2
2
JPI C1
2
JPWR1/JPWR2
JSD1/JSD2
JSTBY1
JTPM1
IPMI_LAN
LAN1/3 & LAN2/4
I-SGPIO 1/2
I-SATA 0-5
S-SATA 0-3
SAS(0-3,4-7
(-for -CLN4 only)
(CPU1) Slot1
X10DRH-CLN4/iLN4 Jumpers
X10DRH-CLN4/iLN4 Connectors
Description
Onboard CMOS battery (See Chpt. 3 for Used Battery Disposal)
Backplane COM Port1/Front accessible COM2 header
CPU/system fan headers (Fan 1-Fan 6, Fan A, Fan B)
24-pin ATX main power connector (See Warning on Pg. 1-6.)
Speaker/Power LED header
Front panel control header
4-pin power connector
4-pin external BMC I
Chassis intrusion header
System management bus (SMBbus) (I
cards
Power supply SMBbus I
12V 8-pin power connectors (See Warning on Pg. 1-6.)
SATA DOM (Device on Module) power connectors 1/2
Standby power connector
TPM (Trusted Platform Module)/Port 80 header
IPMI-Dedicated LAN support by the ASpeed controller
G-bit Ethernet (GLAN) ports 1/3 & 2/4
Seria_Link General Purpose I/O headers 1/2 for SATA ports (I-
SGPIO 1 for I-SATA0-3, I-SGPIO 2 for I-SATA4/5)
SATA 3.0 connectors supported by Intel PCH (I-SATA 0-5), (I-
SATA4/I-SATA5: can be used as Supermicro SuperDOM (Disk-
on-Module) with built-in power connectors)
SATA vertical connector w/4 SATA 3.0 connections (S-SATA 0-3)
SAS 3.0 connections (0-3,4-7) supported by the LSI 3008 (For
X10DRH-CLN4 only)
PCI-Express 3.0 x16 slot from CPU1
1-5
Default Setting
See Chapter 2
Pins 1-2 (Enabled)
Pins 1-2 (Enabled)
Pins 1-2 (Enabled)
Pins 1-2 (Normal)
Pins 1-2 (Enabled)
Pins 1-2 (Reset)
C header (for an IPMI card)
2
C) for NVME add-on
2
C header
2
Chapter 1: Overview