Float Height Adjustment - HYOSUNG Aquil GV650 Service Manual

4-7 FUEL SYSTEM

◉ FLOAT HEIGHT ADJUSTMENT

To check the float height, turn the carburetor upside
down. Measure the float height � while the float arm is
just contacting the needle valve using vernier calipers.
Float height � �
Vernier calipers : 09900 - 20101
● Bend the float arm ① as necessary to bring the
height to the specified level.
● After adjustment, check the float height and the fuel
level again.
◉ REASSEMBLY
Carburetor reassembly can be performed in the reverse
order of disassembly. When reassembling, carefully
observe the following instructions.
● After cleaning, reinstall the pilot screw to the original
number of turn that is recorded during disassem-
bly.
● Fit the seal rings securely to the float chamber and
install the float chamber to the carburetor body.
● Install the three screws ②.
7 mm (0.28 in)
①
�
②