7-13 CHASSIS
◉ CALIPER REASSEMBLY
Reassemble the caliper in the reverse order of
disassembly procedures and observe the following
points.
CAUTION
� Wash the caliper components with fresh brake
fluid before reassembly. Do not wipe off
brake fluid after washing the components.
� Replace the piston seal and dust seal into new
ones with brake fluid applied.
Brake fluid specification and classification
(Front brake) : DOT 3 or DOT 4
(Rear brake) : DOT 4
● Install the brake pad spring.
● Apply SILICONE GREASE to the brake caliper
holder.
SILICONE GREASE
● Install the brake pads. (Refer to page 2-18)
● Tighten the caliper mounting bolts �.
● With the hose end seated to the stopper, tighten
the right and left front brake hose union bolt �.
Front brake caliper mounting bolts
Front brake hose union bolts
● Fill the system with brake fluid and bleed air. (Refer
to page 2-19)
Inspection after reassembly : Refer to page 2-17
: 18~28 N∙m (1.8~2.8 kg∙m)
: 20~25 N∙m (2.0~2.5 kg∙m)
�
[Left front brake]
�