Engine Component Inspection And Service - HYOSUNG Aquil GV650 Service Manual

3-21 ENGINE
● Remove the crankshaft by using the special tool.
Crankcase separator : 09920-13120
ENGINE COMPONENT
INSPECTION AND SERVICE
CAUTION
Be sure to identify each removed part as to its loca-
tion, and lay the parts out in groups designated as
"Front cylinder" , "Rear cylinder" , "Exhaust" ,
"Intake" , so that each will be restored to the origi-
nal location during assembly.
◉ CYLINDER HEAD DISTORTION
Decarbonate in combustion chamber.
Check the gasket surface of the cylinder head for distor-
tion with a straightedage and thickness gauge, taking a
clearance reading at several places as indicated. If the
largest reading at any position of the straightedge
exceeds the limit, replace the cylinder head.
Cylinder head
distortion
Thickness gauge : 09900-20806
◉ VALVE FACE WEAR
Visually inspect each valve face for wear. Replace any
valve with an abnormally worn face. The thickness of
the valve face decreases as the face wears. Measure
the valve head thickness �. If it is out of specification,
replace the valve with a new one.
Valve head thickness
Vernier calipers : 09900-20101
◉ VALVE STEM RUNOUT
Check the valve stem for abnormal wear or bend.
Place the valve on V-blocks and measure runout.
If the service limit is exceeded or abnormal condi-
tion exists, replace the valve.
Valve stem runout
Dial gauge : 09900-20606
Magnetic stand : 09900-20701
V-block : 09900-21304
Service limit
0.05 mm (0.002 in)
Service limit
� �
0.5 mm (0.02 in)
Service limit
0.05 mm (0.002 in)
�