Internal Lto-3 Half-Height Tape Drive Quick Start - Quantum LTO-3 User Manual

Internal LTO-3 Half-Height Tape Drive Quick Start

1
2
3
4
5
6
7
8
9
LTO-3 Half-Height Tape Drive User's Guide
Use the following quick-start procedure to install the internal LTO-3
Half-Height Tape Drive. Print this page and check each step as you
complete it. If you need more information about a step, see the sebsection
referenced in the step.
Unpack the contents of your drive package, and check for damaged items.
See Unpacking and Inspecting the Drive
Review a parallel SCSI drive's default settings and change them if necessary:
• SCSI ID: 6
• Terminator Power: Enabled
See Configuring the Internal Parallel SCSI Tape Drive
Turn off your computer, remove its covers and power cable, and select a mounting
bay for the drive.
See Mounting the Internal Tape Drive
Connect a parallel SCSI or serial-attached SCSI (SAS) interface cable to the drive.
See Connecting the Internal Drive Interface and DC Power Cables
Terminate the parallel SCSI bus if the internal tape drive is the last device on the
SCSI bus.
See figure 3 on page 13.
Connect a serial cable, if installing the tape drive in a tape library system.
See Connecting the Internal Drive Interface and DC Power Cables
Connect a DC power cable to the drive.
See Connecting the Internal Drive Interface and DC Power Cables
Replace the computer covers and AC power cable, turn on the computer, and
verify that the internal tape drive is operating properly.
Register your tape drive.
See Registering the LTO-3 Half-Height Tape Drive
Internal LTO-3 Half-Height Tape Drive Quick Start
on page 8.
on page 10.
on page 13.
on page 25.
Appendix A
on page 15.
on page 15.
on page 15.
86