Internal Tape Drive Mounting Hole Dimensions - Quantum DLT VS160 Product Specification

Internal Tape Drive Mounting Hole Dimensions

2.2 Internal Tape Drive Mounting Hole Dimensions
Figure 2-1
139.7 ± 0.381
[5.500 ± .015]
Figure 2-1. Internal Tape Drive Mounting Hole Dimensions (Bottom View)
N : 1 The dimension referenced in boxed note 1 [1] is from the front of the base plate.
OTES
2 The dimension referenced in boxed note 2 [2] is from the right-side tape drive mounting plane to the
interior guiding surface of the media opening.
3 The dimension referenced in boxed note 3 [3] is from the bottom tape drive mounting hole to the
interior guiding surface of the media opening.
4 The tape drive width and length are standard 5¼-inch form factor measurements.
5 Dimensions are identical on left side and right sides.
6 Dimensions are in millimeters. The dimensions in brackets [x.x] are in inches.
2-4
shows the mounting holes and dimensions in a bottom view for the internal tape drive.
79.38 ± 0.25
[ 3.125 ± .010 ]
September 2004
DLT VS160 Product Specification
48.52± 0.254
1
[ 1.910 ± .010 ]
Data cartridge
127.99
[ 5.04 ]
105.41
[ 4.15 ]
124.84
3
[ 4.92 ]
22.58 ± 0.55
[ .889 ± .021 ]
19.43 ± 0.7
[ .765 ± .027 ]
81-81275-01 REV A02
2