Figure 6 Internal Scsi Drive Interface And Dc Power Connectors; Figure 7 Internal Sas Drive Interface And Dc Power Connectors - Quantum LTO-3 User Manual

Figure 6 Internal SCSI Drive
Interface and DC Power
Connectors
Figure 7 Internal SAS Drive
Interface and DC Power
Connectors
LTO-3 Half-Height Tape Drive User's Guide
• See the internal parallel SCSI bus termination examples in
figure 3 on page 13 to check/verify the system SCSI bus
configuration and install a 68-pin LVD SCSI bus terminator
as required.
b For the SAS internal drive, attach the internal SAS interface cable
to the 7-pin 1x SATA style SAS connector on the back of the
drive.
Serial library port
68-pin parallel SCSI connector
Serial library port
DC power connector
3 If you are installing the internal LTO-3 Half-Height Tape Drive in a
tape library system, connect the RS-422 serial interface cable to the
serial library port on the back of the drive. (The serial library port is
not used on workstation or server systems.)
Chapter 2 Installation Procedures
Installing the Internal LTO-3 Half-Height Tape Drive
DC power connector
7-pin 1x SATA style SAS connector
16