Configuring And Installing An Internal Tape Drive With Scsi Interface; Setting The Internal Tape Drive Scsi Id - Quantum SDLT 600 User Manual

Configuring and Installing an Internal Tape Drive with SCSI
Interface
Setting the Internal Tape
Drive SCSI ID
SDLT 600 Product Manual

Configuring and Installing an Internal Tape Drive with SCSI Interface

5 Confirm that your back-up software and operating system are
compatible with the tape drive. See
up-to-date compatibility information.
This section provides information for configuring and installing a tape
drive with SCSI interface into a system. See
Tabletop Tape Drive with SCSI Interface
configuring and installing a tabletop tape drive.
Before you begin, review the safety, ESD, and handling
Caution:
precautions described at the beginning of this chapter to
avoid personal injury or damage to equipment.
Configuring the SDLT 600 tape drive system with SCSI interface includes
the following tasks:
• Setting the SCSI ID for the tape drive (default = SCSI ID 5)
• Configuring the tape drive to provide TERMPWR
• Setting the configuration jumper (default = wide SCSI enabled).
If you want to change any of the settings, refer to the applicable
subsection; otherwise proceed directly to the tape drive's installation
procedures in Installing the Internal SCSI Tape Drive
Each device on the SCSI bus must have a unique SCSI ID address
assigned to it. For specific recommendations for assigning SCSI IDs, refer
3
to your system or SCSI controller documentation.
Set the SCSI ID by using jumpers on a set of pins at the rear of the tape
drive. This section discusses setting the SCSI ID on the internal tape drive
via the jumper block.
jumper settings.
Chapter 3 Installing Your Tape Drive
www.dlttape.com
on page 60 for information on
Table 25 and table 26
for the most
Configuring and Installing a
on page 47.
show the SCSI ID address and
3
42