Quantum LTO-3 User Manual page 82

LTO-3 Half-Height Tape Drive User's Guide
For the tabletop tape drive:
a Set the drive AC power switch to the off position and re-seat the
AC power cord connector.
b Set the drive AC power switch to the on position and check the
LED.
Power
IF the Power LED is . . .
off,
on,
Chapter 7 Troubleshooting Guide
Troubleshooting Suggestions
THEN . . .
set the drive AC power switch to
the off position, replace the AC
power cable with one from a
known working device, and reset
the AC power switch to the on
position.
If the Power LED:
• Comes on, then resolve the
problem with the AC power
cable/connector.
• Remains off, then contact
Technical Support to resolve the
possible problem with the tape
drive.
repeat step 2 of this procedure to
confirm that re-seating or
replacing the AC power cable
solved the problem and the tape
drive is recognized during system
startup.
If the tape drive is:
• Recognized during the SCSI
controller scan, then the
problem is resolved.
• Still not recognized, then
proceed to step 5 to determine
whether the drive passed the
Power On Self Test functions.
68