Configuring And Installing An Internal Tape Drive - Quantum SDLT 220 User Manual

CHAPTER 4: Installing Your Tape Drive
4.3 Configuring and Installing an Internal
Tape Drive
This section provides information for configuring and installing a tape drive into a
system. See "Configuring and Installing a Tabletop Drive"
configuring and installing a tabletop tape drive.
C
AUTION
Configuration for the SDLT system includes the following:
Setting the SCSI ID for the drive (default = SCSI ID 5).
•
Configuring the drive to provide TERMPWR.
•
Setting the configuration jumper (default = wide SCSI enabled).
•
If you want to change any of the settings, refer to the applicable subsection;
otherwise proceed directly to the tape drive's installation procedures in
the Internal Tape Drive" on page
4-6
: Before you begin, review the safety, ESD, and handling
precautions described at the beginning of this chapter to
avoid personal injury or damage to equipment.
4-11.
March 2004
SDLT 220 and SDLT 320 Product Manual
for information on
"Installing
81-85002-01