Quick Guide To Using Your Receiver; Operation; Changing Channels - Strong SRT 8108 User Manual

PART 2 • English
your language using tu. Once you have selected your language, press q to move the highlight to
the next item and use tu to change.
Language
Region:
Resolution
Aspect Ratio:
Antenna Power:
When all settings have been made, press ok to continue.
noTE:
The receiver will search for all available channels now. Once scanning is finished, the receiver switches
to viewing mode.
TIP:

5.0 QuICk guIdE To uSIng YouR RECEIvER

We at STRONG understand that you can't wait to enjoy your new high definition digital terrestrial
receiver. The following quick guide will make you familiar with the basic operation of this device. We
do, however, advice you to read the full manual to get the best performance from your receiver.
To turn your receiver ON or to Standby, use the q button on the remote control.
Choose the desired channel with the pq buttons. Alternatively, you can digit the channel number
with the 0~9 buttons on the remote control or press ok in viewing mode to display the channel list.
The volume can be adjusted with the tu buttons.

6.0 oPERATIon

Your new receiver is equipped with several features to make watching TV a true pleasure. This
paragraph describes these features. Please also read chapter 7.0 to get familiar with the menu of your
receiver.

6.1 Changing channels

Following ways are possible for changing channels with your new receiver:
Via direct access using the 0~9 buttons.
„ „
Via the channel list through ok and the Pg+/Pg- buttons.
„ „
Here you can choose your language.
Select your region where this receiver is used.
Select the best resolution to according to your screens specification. 576i up
to 1080p.
Use this option to select the aspect ratio of your TV and the preferred
conversion method. Options are: Auto (automatic detection of aspect ratio),
4:3 Panscan (Displays 16:9 widescreen broadcasts full screen on your 4:3 TV),
4:3 letterbox (black bars on top and under the picture on a 4:3 TV) and 16:9
(use this setting for 16:9 TV sets).
Set to On if you use an active antenna. When set to On, 5 V will be present at
the RF IN connector of the receiver. Select Off for passive antennas.
Wrong region selection can lead to missing channels or channels being
stored at wrong positions in the channel list.
If the Welcome menu should not appear after switching on the receiver for
the first time, reset the receiver to factory settings by pressing the mEnu
button and selecting Restore Factory Default in the submenu System.
(dEfAulT PIn: 1234).
7