Operator Information Panel - IBM xSeries 230 6RY Hardware Maintenance Manual

CAUTION:
The power control button on the device and/or the power switch on the power
supply do not turn off the electrical current supplied to the device. The device
also might have more than one power cord. To remove all electrical current from
the device, ensure that all power cords are disconnected from the power source.
v You can turn off the server by pressing the Power control button on the front of
v You can press and hold the Power control button for more than 4 seconds to
v You can disconnect the server power cords from the electrical outlets to shut off

Operator Information panel

The operator information panel on the front of the server contains status lights.
10
Hardware Maintenance Manual: xSeries 230 Models 6RY, 61Y
the server. Pressing the Power control button starts an orderly shutdown of the
operating system, if this feature is supported by your operating system, and
places the server in standby mode.
Note: After turning off the server, wait at least 5 seconds before pressing the
Power control button to power the server on again.
cause an immediate shutdown of the server and place the server in standby
mode. This feature can be used if the operating system hangs.
all power to the server.
Note: Wait about 15 seconds after disconnecting the power cords for your
system to stop running. Watch for the System Power light on the operator
information panel to stop blinking.
1
Information light
2
System error light
3
Ethernet transmit/receive activity light
4
Ethernet link status light
5
Ethernet speed light
6
Power-on light
7
POST complete light
8
SCSI hard disk drive in-use light
OK
TX
100 LINK
MB OK
RX