Replacing The Battery - IBM xSeries 230 6RY Hardware Maintenance Manual

To use this method it is important to know the minimum configuration required
for a system to power up (see page 144). For specific problems, see "Power error
messages" on page 141.

Replacing the battery

IBM has designed this product with your safety in mind. The lithium battery must
be handled correctly to avoid possible danger. If you replace the battery, you must
adhere to the following instructions.
CAUTION:
When replacing the battery, use only IBM Part Number 10L6432 or an equivalent
type battery recommended by the manufacturer. If your system has a module
containing a lithium battery, replace it only with the same module type made by
the same manufacturer. The battery contains lithium and can explode if not
properly used, handled, or disposed of.
Do not:
v Throw or immerse into water
v Heat to more than 100°C (212°F)
v Repair or disassemble
Dispose of the battery as required by local ordinances or regulations.
Note: In the U.S., call 1-800-IBM-4333 for information about battery disposal.
If you replace the original lithium battery with a heavy-metal battery or a battery
with heavy-metal components, be aware of the following environmental
consideration. Batteries and accumulators that contain heavy metals must not be
disposed of with normal domestic waste. They will be taken back free of charge by
the manufacturer, distributor, or representative, to be recycled or disposed of in a
proper manner. To order replacement batteries, call 1-800-772-2227 within the
United States.
Before you begin:
v Read "Before you begin" on page 47.
v Follow any special handling and installation instructions supplied with the
Note: After you replace the battery, you must reconfigure your server and reset
To replace the battery:
1. Turn off the server and peripheral devices and disconnect all external cables
2. Remove the battery:
replacement battery.
the system date and time.
and power cords; then, remove the server cover.
a. Use one finger to lift the battery clip over the battery.
b. Use one finger to slightly slide the battery out from its socket. The spring
mechanism will push the battery out toward you as you slide it from the
socket.
c. Use your thumb and index finger to pull the battery from under the battery
clip.
27
Diagnostics