IBM xSeries 230 6RY Hardware Maintenance Manual page 144

Error Code/Symptom
289 (DIMM has been disabled by the user or
system, see "Memory Settings" on page 34.)
301 (Keyboard or keyboard controller error)
303 (Keyboard controller error)
602 (Invalid diskette boot record)
604 (Diskette drive error)
605 (Unlock failure)
662 (Diskette drive configuration error)
762 (Coprocessor configuration error)
962 (Parallel port error)
11XX (System board serial port 1 or 2 error)
0001200 (Machine check architecture error)
0001295 (ECC circuit check)
2
1301 (I C cable to front panel not found)
136
Hardware Maintenance Manual: xSeries 230 Models 6RY, 61Y
FRU/Action
1. Run Configuration/Setup, if disabled by user
2. Disabled DIMM, if not disabled by user.
3. System Board
1. Keyboard
2. System Board
1. System Board
2. Keyboard
1. Diskette
2. Diskette Drive
3. Cable
4. System Board
1. Run Configuration/Setup and Diagnostics
2. Diskette Drive
3. Drive Cable
4. System Board
1. Diskette Drive
2. Drive Cable
3. System Board
1. Run Configuration/Setup and Diagnostics
2. Diskette Drive
3. Drive Cable
4. System Board
1. Run Configuration/Setup
2. Battery
3. Processor
1. Disconnect external cable on parallel port.
2. Run Configuration/Setup
3. System Board
1. Disconnect external cable on serial port.
2. Run Configuration/Setup
3. System Board
1. Processor
2. Optional Processor
3. System Board
1. System Board
1. Cable
2. Front Panel
3. Power Switch Assembly
4. System Board