IBM xSeries 230 6RY Hardware Maintenance Manual page 134

Beep/Symptom
2-1-2 (Primary DMA register failed)
2-1-3 (Primary interrupt mask register
failed)
2-1-4 (Secondary interrupt mask register
failed)
2-2-2 (Keyboard controller failed)
2-2-3 (CMOS power failure and
checksum checks failed)
2-2-4 (CMOS configuration into
validation failed)
2-3-1 (Screen initialization failed)
2-3-2 (Screen memory failed)
2-3-3 (Screen retrace failed)
2-3-4 (Search for video ROM failed)
2-4-1 (Search for video ROM failed)
3-1-1 (Timer tick interrupt failed)
3-1-2 (Interval timer channel 2 failed)
3-1-3 (RAM test failed above address
OFFFFH)
3-1-4 (Time-Of-Day clock failed)
3-2-1 (Serial port failed)
3-2-2 (Parallel port failed)
3-2-4 (Failure comparing CMOS memory
size against actual)
3-3-1 (Memory size mis-match occurred;
see "Memory Settings" on page 34)
3-3-2 (Critical SMBUS error occurred)
126
Hardware Maintenance Manual: xSeries 230 Models 6RY, 61Y
FRU/Action
1. System Board
1. System Board
1. System Board
1. System Board
1. Battery
2. System Board
1. Battery
2. System Board
1. Jumper on J14
2. System Board
1. System Board
1. System Board
1. System Board
1. System Board
1. System Board
1. System Board
1. DIMM
2. System Board
1. Battery
2. System Board
1. System Board
1. System Board
1. DIMM
2. System Board
3. Battery
1. DIMM
2. System Board
3. Battery
1. Disconnect the server power cord from outlet, wait 30 seconds and
retry.
2. System Board
3. DIMMs
4. DASD Backplane
5. Power Supply
6. Power Supply Backplane
7. 12C Cable