IBM xSeries 230 6RY Hardware Maintenance Manual page 102

94
Hardware Maintenance Manual: xSeries 230 Models 6RY, 61Y
Network Driver Configuration window will appear.
Follow these steps to continue configuring the system:
a. Enter a System Name.
Enter a name for the system in the System Name field. This name will
help other Netfinity Manager users identify the system on the network.
b. Select a Network Driver.
Select one of the available Network Drivers that are displayed in the
Network Drivers field. Once selected, the Network Driver will assign a
network address to the system.
Notes:
1) The fields that appear beneath the Driver Enabled check box will
change depending on which Network Driver you select.
2) When enabling the IPX or TCP/IP Network Driver, the network
address cannot be altered, and it will not appear on the screen. No
field will appear beneath the Driver Enabled check box if you select
the IPX or TCP/IP Network Driver.
3) When enabling the NetBIOS Network Driver, a network address will
be selected and displayed in the Network Address field. To change
this default name, enter any 1–8 character address. However, this
address must be unique to the system. If this NetBIOS address is
identical to the NetBIOS address of another system on the network, it
will prevent Netfinity Manager from starting properly.
4) When enabling the Serial Netfinity Manager driver, type a name that
will be used to identify the system in the Unique Machine Dialup
Name field. This name can be up to 32 characters long, and must be
unique to the system. If this name is not unique, it can prevent remote
Netfinity Manager users from using the Serial Connection Control
service to access the system.
c. Enable the Network Driver.