IBM xSeries 230 6RY Hardware Maintenance Manual page 70

Your server comes with a DIMM installed on the system board in connector J23.
Notes:
1.
2.
3.
To install a DIMM:
1. Review the information in "Before you begin" on page 47 and the
2. Turn off the server and peripheral devices and disconnect all external cables
3. Touch the static-protective package containing the DIMM to any unpainted
4. Install the DIMM:
62
Hardware Maintenance Manual: xSeries 230 Models 6RY, 61Y
Install additional DIMMs in connectors J21, J19, and J18, in that order. (See the
following illustration for memory connector locations.)
Your xSeries 230 server supports 128 MB, 256 MB, 512 MB, and 1 GB DIMMs.
Your server supports a minimum of 128 MB and a maximum of 4 GB of system
memory.
Installing or removing DIMMs changes the configuration information in the
server. Therefore, after installing or removing a DIMM, you must save the new
configuration information by using the Configuration/Setup Utility program.
When you restart the server, the system displays a message indicating that the
memory configuration has changed. Start the Configuration/Setup Utility
program and select Save Settings. See "Configuring the server" on page 31 for
more information.
1
DIMM 2
2
DIMM connector 4 (J18)
3
DIMM connector 3 (J19)
4
DIMM connector 2 (J21)
5
DIMM connector 1 (J23)
6
DIMM 1
documentation that comes with your option.
and power cords; then, remove the cover (see "Removing the cover, door, and
bezel" on page 48 for details).
metal surface on the server. Then, remove the DIMM from the package.
Note: To avoid breaking the retaining clips or damaging the DIMM connectors,
handle the clips gently.
a. Turn the DIMM so that the pins align correctly with the connector.