Starting The Server - IBM xSeries 230 6RY Hardware Maintenance Manual

1
AC power LED
2
DC power LED
AC Power Light:This light provides status information about the power supply.
During normal operation, both the AC and DC Power lights are on. For any other
combination of lights, see "Power supply LEDs" on page 14.
DC Power Light:This light provides status information about the power supply.
During normal operation, both the AC and DC Power lights are on. For any other
combination of lights, see "Power supply LEDs" on page 14.

Starting the server

After you have plugged the power cord of your server into an electrical outlet and
the power supply has been turned on, the server can be activated in several ways:
v You can turn on the server by pressing the Power control button on the front of
the server.
Note: If you have just plugged the power cord of your server into an electrical
outlet, you will have to wait approximately 20 seconds before pressing the
Power control button.
v If the server is activated and a power failure occurs, the server will start
automatically when power is restored.
v Pressing the Reset button resets the server and runs the power-on self-test.
v The server can also be powered on by the Netfinity Advanced System
Management Processor.
Deactivating the server
The server can be deactivated as follows:
9
General information