IBM xSeries 230 6RY Hardware Maintenance Manual page 139

Error Code/Symptom
165-XXX-000 (Failed Service Processor test)
180-XXX-000 (Diagnostics LED failure)
180-XXX-001 (Failed information LED panel
test)
180-XXX-002 (Failed Diagnostics LED Panel
test)
180-XXX-003 (Failed System Board LED
test)
180-XXX-004 (Failed Processor Board LED
test)
180-XXX-005 (Failed SCSI Backplane LED
test)
180-XXX-006 (Memory Board LED test)
201-XXX-0NN (Failed Memory test, see
"Memory Settings" on page 34.)
201-XXX-999 (Multiple DIMM failure, see
error text.)
202-XXX-001 (Failed System Cache test)
202-XXX-002 (Failed System Cache test)
206-XXX-000 (Failed Diskette Drive test)
215-XXX-000 (Failed IDE CD-ROM test)
217-XXX-000 (Failed BIOS Fixed Disk test)
Note: If RAID is configured, the fixed disk
number refers to the RAID logical array.
217-XXX-001 (Failed BIOS Fixed Disk test)
Note: If RAID is configured, the fixed disk
number refers to the RAID logical array.
217-XXX-002 (Failed BIOS Fixed Disk test)
Note: If RAID is configured, the fixed disk
number refers to the RAID logical array.
FRU/Action
1. System Board. Before replacing the System Board, ensure that
System Board jumper J45 is not installed (the default) when the
error occurs.
2. Power Backplane
3. Hot-Swap Drive Backplane
1. Run Diagnostic LED test for the failing LED.
2. Power Switch Assembly
1. Information LED Panel
2. Diagnostic LED Panel
1. Diagnostics LED Panel
2. Power Switch Assembly
1. System Board
1. System Board
1. SCSI Backplane
2. SCSI Backplane Cable
3. System Board
1. Memory
2. System Board
1. DIMM Location DIMM1 - DIMM4 where NN = 1 = DIMM2, 2 =
DIMM1, 3 = DIMM4, 4 = DIMM3.
2. System Board
1. See error text for failing DIMMs
2. System Board
1. VRM 1
2. Microprocessor 1
1. VRM 2
2. Microprocessor 2
1. Cable
2. Diskette Drive
3. System Board
1. CD-ROM Drive Cables
2. CD-ROM Drive
3. System Board
1. Fixed Disk 1
1. Fixed Disk 2
1. Fixed Disk 3
131
Symptom-to-FRU index