8CH-10
8ED-10
6. Install:
•
Handlebar
CAUTION:
•
For SX600/MM600:
Be sure the projection on the handlebar is not
installed into the area a shown.
•
Be sure the side of the holder with the small
gap b faces forward.
SEA3150
•
Center the match mark c on the handlebar 1
between the lower handlebar holders 2.
Bolt (handlebar holder):
CAUTION:
•
First tighten the bolts on the front side of the
handlebar holder, and then tighten the bolts
on the rear side.
SEA3160
•
For SX600/MM600:
The handlebar for the SX600 (8EA4) has "8CH-
10" stamped on one end for identification. The
handlebar for the MM600 (8EJ3) has "8ED-10"
stamped on one end. Since these handlebars
are specifically designed for the SX600 (8EA4)
and MM600 (8EJ3), do not use them on any
future models.
SEA3170
SEA3180
3-7
CHAS
STEERING
23 Nm (2.3 m · kg, 17 ft · lb)