Yamaha VX600ERG Service Manual page 85

LT
4. Install:
•
Relay rod 1
NOTE:
Make sure that the end of the relay rod with the
indentation a is connected to the relay arm.
CAUTION:
Always use new cotter pins.
SEA3130
Nut (relay rod):
5. Adjust:
•
Skis
Adjustment steps:
•
Temporarily install the handlebar.
•
Hold the handlebar straight and check that the
skis are at right angles to the handlebar.
•
Loosen the locknuts (relay rod) 1.
•
Position the skis parallel in the riding direction.
•
With the skis in this position, turn the relay rod 2
in either direction until the handlebars at right
angles with respect to the direction of movement.
Turning the relay rod
in direction a
Turning the relay rod
in direction b
•
Tighten the locknuts (relay rod) 1.
SEA3140
Locknut (relay rod):
3-6
CHAS
STEERING
35 Nm (3.5 m · kg, 25 ft · lb)
Turning the handlebar
in direction c
Turning the handlebar
in direction d
25 Nm (2.5 m · kg, 18 ft · lb)
®
LOCTITE