3
COOLING SYSTEM/
CARBURETOR SYNCHRONIZATION
•
•
•
SEA2260
3. Install:
CARBURETOR SYNCHRONIZATION
1. Remove:
2. Adjust:
Adjustment steps:
•
•
SEA2270
•
•
3. Install:
SEA2280
2-12
Remove the coolant filler cap and bleed the
cooling system again, as described above.
No air bubbles → OK.
Add coolant to the specified level.
Pour coolant into the coolant reservoir 3 until
the coolant level reaches the "FULL" level mark.
•
Bleed bolt cap (MM600)
•
Rear bumper cover (VT600)
•
Seat (VX600ER/SX600/VT600)
•
Carburetors
Refer to "CARBURETORS" in CHAPTER 7.
•
Carburetor synchronization
Turn the throttle stop screw 1 of carburetor #2
until the specified throttle valve height a is ob-
tained.
Throttle valve height:
1.2 mm (0.047 in)
Adjust the throttle valve height a on carburetor
#1 2 and #3 3 with the adjusting screws 4.
Move the throttle lever 2 ~ 3 times.
Make sure that all of the carburetor throttle valves
are at the same height.
•
Carburetors
Refer to "CARBURETORS" in CHAPTER 7.
INSP
ADJ