Yamaha VX600ERG Service Manual page 284

1 Make sure a plastic band is
routed through the projection
located on the silencer, when
fastening it around the wire
harness and the starter cable.
(VX600ER/VT600)
2 Starter cable
3 Make sure the plastic bands are
routed through the projection
located on the silencer, when
fastening them around the wire
harness.
4 Connectors of the carburetor
switch
5 Water temperature sensor
coupler
6 Starter relay lead (VX600ER/
VT600)
7 Ignition coil coupler
8 To filler cap body.
9 Make sure a plastic band is
fastened around the wire harness
to prevent the coolant reservoir
hose from kinking.
0 AC magneto couplers
A Starter relay coupler (SX600/
MM600)
B To the coolant reservoir tank
C Coolant reservoir hose
D Wire harness
E Gear position switch (VX600ER/
VT600)
F Route the parking brake cable
outside the gear position switch
leads.
a 0 ~ 5 mm (0 ~ 0.20 in)
CABLE ROUTING
9-38
SPEC