Complete The Field Wiring - Superior DRL6542TEN Installation And Operation Instructions Manual

Innovative Hearth Products
Superior DRL6000 Series Direct-Vent Gas Fireplaces
TM
e. Slide the gear clamp down and tighten it fully to secure the flexible vent to the adaptor outer collar
f. Install three (3) screws 120° apart through the flexible vent and into the adaptor collar just below the gear
3. Route the flexible vent.
NOTE: Ensure that the flexible vent is properly routed to provide the required clearance. Do NOT allow the flexible vent
to bend in a radius tighter than 5" (127 mm) (Figure 31). Place the internal flexible vent spacers evenly and avoid
kinking the inner vent. Support horizontal sections of flexible vent with metal straps at 2 ft (0.61 m) intervals.
4. Install firestop/spacers at ceiling and wall penetrations.
•
•
NOTE: See the appropriate sections and figures shown throughout the venting section for installation
requirements.
5. Attach the flexible vent to the termination.
NOTE: Secure Flex
vent cut to size at the job site. Attach the flexible vent to the Secure Flex terminations as it was attached to the
adaptor (Figure 30).
NOTE: Attach Secure Flex vent to Secure Flex terminations only. Do NOT substitute Secure Vent
or Secure Vent adaptor for Secure Flex components. Secure Flex termination and adaptor collars are a
different circumference than Secure Vent collars. Secure Flex vent has a longer center tube to improve
ease-of-installation.

Complete the Field Wiring

10.
The ground supply lead must be connected to the wire attached to the green ground screw
located on the outlet box (see wiring diagrams). Failure to do so will result in a potential
safety hazard. The appliance must be electrically grounded in accordance with local codes
or, in the absence of local codes, the National Electrical Code, ANSI/NFPA 70—latest
edition (in Canada, the current CSA C22-1 Canadian Electrical Code).
Label all wires prior to disconnection when servicing controls. Wiring errors can cause
improper and dangerous operation.
Au moment de l'entretien des commandes, étiquetez tous les fils avant de les débrancher.
Des erreurs de cáblage peuvent entraîner un fonctionnement inadéquat et dangereux.
Verify proper operation after servicing.
S'assurer que l'appareil fonctionne adéquatement une fois l'entretien terminé.
The gas valve is set in place and pre-wired at the factory.
Wire the fireplace
NOTE: Must be connected to the main power supply.
1. Route a 3-wire, 120 Vac, 60 Hz, 1 ph power supply to the fireplace junction box.
NOTE: The junction box can be moved to the bottom of the box or to the right side (Figure 34). To move the
junction box remove the cover plate, compress junction box to release it from the fireplace. Select the new
location. For the bottom location, install the 3-wire 120 Vac supply wire and strain relief in the hole provided.
Connect the wires (Figure 32). Reinstall the junction box by compressing the sides, then place the small flange
of the Junction box in the small slot. Place the larger flange into the larger slot and release. Reinstall the cover
over the original junction box location.
approximately 3/4" from the end of the flexible vent.
clamp to provide additional security to the connection.
SF4.5 VF firestop/spacer for ceilings
SF4.5 HF firestop/spacer for walls
components can be purchased separately and attached to bulk lengths of Secure Flex flexible
®
CAUTION
CAUTION
ATTENTION
Installation
900077-00, 03/2014
terminations
®
35