Optional: Install The Bezel - Superior DRL6542TEN Installation And Operation Instructions Manual

Innovative Hearth Products
Superior DRL6000 Series Direct-Vent Gas Fireplaces
TM
Figure 45: Installing the Surround
Figure 47: Wall Receiver Switch

Optional: Install the Bezel

23.
1. See Page 58 for instructions on Installing the Optional Bezel.
Optional: Install the Modesty Panel
24.
1. Insert the four (4) hooks on the modesty panel into the four slots on the door flange (Figure 49).
Figure 49: Installing the Modesty Panel
2. Slide the modesty panel to the left until it is fully seated (Figure 49).
Three-position slider switch in
REMOTE position
On
Remote
Off
PRG
Modesty Panel
Figure 46: Noncombustible Material with Surround and Bezel
Top Nailing
Flange
Remove Left
(and Right)
SIDE Nailing
Flanges.
Bezel
Remove Left
(and Right)
Filler/Angle Brackets.
Surround/Bezel Finish
Figure 48: Remote Control Transmitter
1. Cut TOP Non-Combustible Fiber Board to height of installed Top Spacers,
and secure to TOP Nailing Flange using field-provided screws.
2. Do NOT install Left and Right Side Fiber Boards.
3. REMOVE Left and Right SIDE Nailing Flanges.
4. REMOVE Left and Right Filler (Angle) Brackets.
UP/DOWN
Arrow Key
MODE Key
Installation
900077-00, 03/2014
Top Non-Combustible Fiber Board
Cut to height of installed Top Spacers.
LCD Display
ON/OFF Key
ROOM
TEMPERATURE
Key
Slot on
Hook on
door flange
modesty panel
Insert hooks into slots
(4 places), then slide
panel left until seated
43