Installation Sequence; Construct The Fireplace Framing - Superior DRL6542TEN Installation And Operation Instructions Manual

Innovative Hearth Products
Superior DRL6000 Series Direct-Vent Gas Fireplaces
TM

INSTALLATION SEQUENCE

The typical sequence of installation is outlined below; however, each installation is unique and may result in
variations to the steps described.
See the pages referenced in the following steps for detailed instructions.
Framing
1. Construct the Fireplace Framing (Page 16).
2. Prepare the Fireplace Top Spacers (Page 18).
3. Route the Gas Supply Line into the Fireplace (Page 18).
4. Rough in the Electrical Supply, if Needed (Page 19).
5. Prepare the Fireplace Nailing Flanges (Page 19).
6. Place the Fireplace in the Framing and Secure (Page 20).
Venting
7. Select a Horizontal or Vertical Vent System (Page 20).
8. Install the Vent Restrictor (if necessary) (Page 20).
9. Install the Vent System (Page 24).
Electrical Connection
10. Complete the Field Wiring (Page 35).
11. Optional: Wire and Install the Power Vent (Page 37).
12. Optional: Route Backlighting Wiring (Page 37).
Gas Connection
13. Connect the Gas Line (Page 37).
14. Verify Proper Fireplace Operation (Page 38).
Finishing
15. Optional: Install the Backlighting Reflector (Page 39).
16. Install the Firebox Liners (Page 56).
17. Optional: Install the Backlighting Light Assemblies (Page 39).
18. Install the Glass Media (Page 56).
19. Install the Baffle (Page 39).
20. Install the Glass Door (Page 57).
21. Adjust the Air Shutter to Ensure Proper Flame Appearance (Page 39).
22. Install the Finishing Materials (Page 41).
23. Optional: Install the Bezel (Page
24. Install the Wall Switch Receiver (Page
25. Initialize the Remote Control System (Page
26. Attach the Safety-in-Operation Warning Labels (Page 44).

Construct the Fireplace Framing

1.
1. Frame the fireplace as illustrated in Table 10. All framing details must allow for a minimum clearance to combustible
2. Mount the fireplace on a fully supported base extending the full width and depth of the unit. If installed on
NOTE: Headers may be in direct contact with the fireplace top standoff spacers when they are bent up vertically,
maintaining the 9 3/8" clearance to the fireplace top, but must not be supported by them or notched to fit around
them. All construction above the fireplace must be self-supporting. DO NOT use the fireplace for structural support.
16
framing members as shown in Table 8. Steel studs are strongly recommended where exposed to heat.
combustible materials, such as carpeting, vinyl tile, or combustible material other than wood flooring, the
appliance shall be installed on a metal or wood panel extending the full width and depth of the fireplace.
43).
44).
44).
Installation
900077-00, 03/2014