Table of Contents
Advertisement
806f0207-0301ffff
[ProcessorElementName] has Failed with FRB1/BIST condition. (CPU 1)
Explanation: This message is for the use case when an implementation has detected a Processor Failed - FRB1/BIST
condition.
May also be shown as 806f02070301ffff or 0x806f02070301ffff
Severity: Error
Alert Category: Critical - CPU
Serviceable: Yes
CIM Information: Prefix: PLAT and ID: 0044
SNMP Trap ID: 40
Automatically notify Support: Yes
User response:
1.
Make sure that the latest levels of firmware and device drivers are installed for all adapters and standard devices
such as Ethernet and storage adapters. Important: Some cluster solutions require specific code levels or
coordinated code updates. If the device is part of a cluster solution, verify that the latest level of code is
supported for the cluster solution before you update the code.
2.
Update the firmware (UEFI and IMM) to the latest level (Updating the firmware).
3.
Run the DSA program.
4.
Remove the adapter to see if the problem is follwed adapter. if not, replace the adapter.
5.
(Trained technician only) Replace microprocessor n.
6.
(Trained technician only) Replace the system board. (n = microprocessor number)
806f0207-0302ffff
[ProcessorElementName] has Failed with FRB1/BIST condition. (CPU 2)
Explanation: This message is for the use case when an implementation has detected a Processor Failed - FRB1/BIST
condition.
May also be shown as 806f02070302ffff or 0x806f02070302ffff
Severity: Error
Alert Category: Critical - CPU
Serviceable: Yes
CIM Information: Prefix: PLAT and ID: 0044
SNMP Trap ID: 40
Automatically notify Support: Yes
User response:
1.
Make sure that the latest levels of firmware and device drivers are installed for all adapters and standard devices
such as Ethernet and storage adapters. Important: Some cluster solutions require specific code levels or
coordinated code updates. If the device is part of a cluster solution, verify that the latest level of code is
supported for the cluster solution before you update the code.
2.
Update the firmware (UEFI and IMM) to the latest level (Updating the firmware).
3.
Run the DSA program.
4.
Remove the adapter to see if the problem is follwed adapter. if not, replace the adapter.
5.
(Trained technician only) Replace microprocessor n.
6.
(Trained technician only) Replace the system board. (n = microprocessor number)
806f0207-0301ffff • 806f0207-0302ffff
Appendix A. Integrated management module II (IMM2) error messages
477
Advertisement
Chapters
Table of Contents
Troubleshooting
