Replacing An Adapter - IBM System x3650 M5 Installation And Service Manual

Replacing an adapter

Use this information to replace an adapter.
Replacing an adapter in a riser-card assembly:
Use this section to replace an adapter in a riser-card assembly.
About this task
The following illustration shows the locations of the adapter expansion slots from
the rear of the server.
Slot 1
Slot 2
Slot 3
Figure 119. PCI riser-card adapter expansion slot locations
Slot 1
Slot 2
Slot 3
Figure 120. PCI riser-card adapter expansion slot locations
Slot 3
Figure 121. PCI riser-card adapter expansion slot locations
The following table describes the maximal card dimension supported in each slot.
190
System x3650 M5 Type 5462: Installation and Service Guide
2.5-inch rear two
hard-disk-drive kit
Table 13. The maximal card dimension supported in each slot
Riser-card assembly
Riser-card assembly 1
Slot 4 Slot 5
Slot 4 Slot 5
Slot 4 Slot 5
Slot
number The maximal card dimension supported
1 Full height, up to full length
2 Full height, up to full length
3 Full height, half length
4 Low-profile
5 Low-profile
3.5-inch rear two
hard-disk-drive kit
3.5-inch rear two
hard-disk-drive kit
Slot 6
Slot 7
Slot 8