Removing The Top Cover - IBM System x3650 M5 Installation And Service Manual

Removing the top cover

Use this information to remove the top cover.
About this task
To remove the top cover, complete the following steps:
Procedure
1. Read the safety information that begins on page "Safety" on page vii and
2. Turn off the server and peripheral devices and disconnect the power cords and
3. If the server has been installed in a rack, press down on the left and right side
Figure 68. Top cover removal
4. ▌1▐Push the cover-release latch back, ▌2▐then lift it up. Slide the cover back,
5. If you are instructed to return the top cover, follow all of the packaging
146
System x3650 M5 Type 5462: Installation and Service Guide
"Installation guidelines" on page 283.
all external cables, if necessary.
latches and slide the server out of the rack enclosure until both slide rails lock..
and▌3▐then lift off the server. Set the cover aside.
Attention: For proper cooling and airflow, replace the server cover before you
turn on the server.
instructions, and use any packaging materials for shipping that are supplied to
you.
3
2
1
Cover-release latch