Removing The System Board - IBM System x3650 M5 Installation And Service Manual

Figure 240. Heat-sink retention module installation
10. Slide the server into the rack.
11. Reconnect the power cords and any cables that you removed.
12. Turn on the peripheral devices and the server.

Removing the system board

Use this information to remove the system board.
About this task
Notes:
1. When you replace the system board, you must either update the server with
2. When you replace the system board, make sure that you remove the Integrated
3. Before you replace the system board, make sure that you back up any features
To remove the system board, complete the following steps:
276
System x3650 M5 Type 5462: Installation and Service Guide
Heat sink retention module
7. Reinstall the heat sink (see "Replacing a microprocessor and heat sink" on
page 264).
Attention: Make sure that you install each heat sink with its paired
microprocessor.
8. Reinstall the air baffle (see "Replacing the air baffle" on page 149).
9. Install the top cover (see "Replacing the top cover" on page 147).
the latest firmware or restore the pre-existing firmware that the customer
provides on a diskette or CD image. Make sure that you have the latest
firmware or a copy of the pre-existing firmware before you proceed.
Management Module Advanced Upgrade and place it on the new system
board. For information about the Advanced Upgrade, see "Using the remote
presence and blue-screen capture features" on page 57.
on demand (FoD) keys that were enabled. Reactivate any Features on Demand
features. Instructions for automating the activation of features and installing
activation keys is in the IBM Features on Demand User's Guide. To download the
document, go to /http://www.ibm.com/systems/x/fod/, log in, and click
Help.