Table of Contents
Advertisement
Noisy stereo reception
Maybe a weak station. Set the
l
the STEREO SETUP
menu to
Mode: mono.
No picture, no sound but power light is on
(
Wrong antenna input
or
A
l
(antenna) button on master remote. Details are on page 41.
function on
Cable/air
SETUP
l
changed. Details are on page 40.
Maybe a vacant channel is tuned.
l
For channels 9 1 and 92, make sure the component connected
l
those
to
jacks is turned on.
INPUT
If watching VCR (connected only through antenna input),
l
make sure TV is tuned to channel 3 or 4 - same as
switch on VCR. Also check to make sure
VCR is in correct position.
Sound okay, picture poor
Check antenna connections.
l
Try adjusting
function to improve weak signals.
SHARPNESS
l
If recording one channel on VCR connected to
l
watching another channel on the TV, make sure the VCR's
switch is in correct position
No picture while using picture-in-picture with VCR, laser
disc player, or camcorder.
If using an S-VHS component, make sure its regular video
l
to
cable is also connected
the
video can not be viewed on the small picture.
If using the
or
button, make sure it is programmed to
l
select the proper channel as described on page 43.
No audio while using picture-in-picture with VCR, laser disc
player, or camcorder.
Be sure to connect audio cables in addition to S-VHS cable.
l
The S-VHS cable carries only video, no audio.
TV shuts off and then comes right back on
Power interruption may have occurred.
l
Automatic shutdown circuit may have been triggered as
l
described on page 4.
function in
Mode: stereo/mono
Details are on page 28.
)
selected. Try pressing
B
ANT
menu has been accidentally
CH
switch on
input and
ANT
(VCR
indicator turned off).
jack on the TV. S-VHS
INPUT
Advertisement
Table of Contents
