Table of Contents
Advertisement
If your cable box has its own remote to change channels,
you will probably be able to program the TV's remote to
control both the TV and the cable box.
The TV's remote is designed to control several brands of
cable boxes. To program the remote, just press
then the two-digit code number for your brand of cable
,
ID
box. Refer to the chart below to find the code number for
your cable box. Press the
OFF
operation. You may need to try each of the code numbers
listed until you find the one that works.
Press OFF/ON -
4
to test.
3 Press two number
b u t t o n s -
(See list below.)
Eastern International
General Instrument
Hamlin
Hitachi
Jerrold
MACOM
Magnavox
NSC
Oak Sigma
Panasonic
Philips
Pioneer
Randtek
R C A
Regal
Scientific Atlantic
Svlvania
Teknika
Texscan
Tocom
Unika
Zenith
Note: Refer to the information sheet packed with your remote control
for the latest list of brand names and code numbers. Because this list is
constantly growing, the information sheet packed with your remote
control may be a later version of this list and contain additional brands
and/or code numbers.
then
,
CABLE
button next to confirm
/
ON
-1 Press
CABLE
Press IO
12, 13, 34
01. 16. 38
18.20
03.22
10.11
17.21
14.42
_
_
After the TV's remote is programmed, you will be able to
turn on the cable box by pressing
can change channels on the cable box by pressing the
buttons whenever the remote is in the "cable
CHANNEL
mode?. To put the remote in the "cable mode", press the
button. Press the TV button to put the remote back
CABLE
into the "TV mode" so the remote buttons will control the
TV again.
Programming Remote To Control Cable Box
with master remote control only
Refer to the chart at the left to find the code number that
corresponds to the brand name of your cable box. Keep
this number in mind. If more than one number is listed,
you may need to try each one separately until you find the
one that works.
Press
button on remote.
C A B L E
Press
button on remote.
I D
Press two number buttons (first one, then the other)
the code number for your brand of cable box.
Note: You must press the two number buttons within three seconds
of pressing the
button.
ID
Point the remote at the cable box and press the
to test the code number.
If the right number was entered, the cable box should turn
l
08
on.
Pressing the
02
channels on the cable box.
If the cable box does not react to the remote (or if the remote
l
turns on the cable box but does not change channels), repeat
steps 1 through 5 with another code number.
Operating Notes: After the remote control is programmed, it will
09
To turn off the cable box, press
To change channels on the cable box, press
up or down.
1 6
After you program the remote control, you can use the
Setup
function on the
box and tune the TV to the correct channel for the cable box when
press the
button. Details are on page 43.
you
CABLE
27
02
1 1
06
31
then
CABLE
OFF
buttons should then also change
C H A N N E L
and then
CABLE
then
,
/
.
CABLE
OFF
ON
then
CABLE
menu to automatically turn on the cable
SETUP
You
/
.
ON
to enter
button
/
OFF
ON
/
.
OFF
ON
CHANNEL
Advertisement
Table of Contents
