Table of Contents
Advertisement
These connections allow you to record TV programs and play back tapes.
Preferred Method
Z-Way Signal SplilteP
(such as #AliO47)
Incoming Cable horn
Antenna or Cable-N System
* There optional accessories (one AtlO47-
l
cables, and one AH077G-audiolvidso cable)
Shown here is the preferred method of connecting a VCR to
your TV if you are in an area with good signal reception.
This method uses a a-way signal splitter to run separate
signals to the VCR and TV. This way you can view either TV
programs or VCR tapes and not be concerned about the
position of the VCR's W/VCR switch. If your cable company
requires a decoder box for premium channels, refer to
page 63.
Note: The audio/video connections from the VCR to the TV are
required for you to watch tapes being played by the VCR.
Optional S-VHS (Super VHS): If your VCR has an
or
connector, connect it
S-VHS OUT
Simplified Method
Coaxial Antenna Cables+
( s u c h as A H 0 3 7 o r AH0651
Shown here is a simplified method of connecting a VCR to
your TV. This method is best for areas with poor signal
reception. If your cable company requires a decoder box for
premium channels, refer to page 63.
Note: The audio/video connections from the VCR to the TV are
optional; however, these additional connections usually produce a better-
quality picture during VCR playback. These connections are required
for stereo or S-VHS playback from VCR's.
Optional S-VHS (Super VHS): If your VCR has an
connector, connect it to the
-
O
S
VIDEO
UT
connector on the TV in addition to the other three audio and
video cables. An optional S-VHS cable is required. S-VHS
can not be viewed on the small PIP (Picture-In-Picture)
picture.
* Optional accessories are available from most dealers and electronics supply stores.
Coaxial Antenna Cables'
-
S
VIDEO
the
to
S-VIDEO INPUT 1
or
-
S
VHS
-
S
VIDEO INPUT
Optional S-VHS Cable* (such II 18
connector on the TV in addition to the other three audio and
video cables. An optional S-VHS cable is required. S-VHS
can not be viewed on the small PIP (Picture-In-Picture)
picture.
Operation: If the VCR is connected to
shown, select TV channel 9 1 to view whatever the VCR is
playing.
If you connect a second audio/video device to
TV channel 92 to view whatever the second device is playing.
Note: You can program your TV to automatically select the proper VCR
input channel (91 or 92) when you press the
are on page 43.
Operation: If the VCR is only connected to the
connector (no audio or video cables connected), select TV
channel 3 or 4 to see the signal from the VCR (the same
channel the
switch is set to on the VCR).
If the VCR is also connected to the
select TV channel 91 to view whatever the VCR is playing.
If you connect a second audio/video device to
TV channel 92 to view whatever the second device is playing.
Note: You can program your TV to automatically select the proper VCR
input channel (3,4,91, or 92) when you press the
Details are on page 43.
Mail orderform is on page 75.
INPUT
select
2,
INPUT
Details
or
button.
VCR1
ANT
INPUT
select
2,
INPUT
or
button.
VCR1
Advertisement
Table of Contents
