Table of Contents
Advertisement
Troubles sometimes are caused by simple "faults" that you
can easily correct without the help of a service technician by
first checking a few basic remedies.
Before you call or take your unit to an Authorized ProScan
TV Servicenter, look below for the type of trouble you are
experiencing. Then perform the simple checks and
adjustments listed for that trouble.
TV will not turn on
Check to make sure it is plugged in.
l
Check the wall receptacle (or suitable power strip) to make
l
sure it is "live" by plugging in something else.
Maybe batteries in remote control are "dead'.
l
Maybe remote control was not aimed at remote sensor.
l
Controls do not work
If using master remote control, make sure remote is in "TV
l
Mode" by first pressing
T V
Try unplugging set for 15 to 20 minutes and then turning it
l
on again.
Intermittent or no remote
Maybe something was between the remote and the remote
l
sensor.
Maybe the remote was not aimed directly at the component
l
(TV, VCR, cable box, etc.) you were trying to control.
Maybe master remote is not in "TV Mode". Press the N
l
button so master remote will control TV.
Maybe batteries in remote are weak or dead. Try replacing
l
batteries.
Maybe batteries were installed incorrectly. Try replacing
l
batteries correctly.
Check to see if remote is working by pressing any button on
l
the remote. If the remote is working, the power indicator on
the front of the TV will flicker when you press a button on
the remote.
Turns off while playing
function may have been activated.
SLEEP TIMER
l
function may have been activated.
SCHEDULER
l
Electronic protection circuit may have been activated
l
because of a power surge. Wait 30 seconds and then turn on
again. If this happens frequently, the voltage in your house
may be abnormally high.
button.
Turns on unexpectedly
function may have been activated.
l
SCHEDULER
SCHEDULER does not turn TV on and off at correct time
Check
functions. Make sure time (including am
l
SCHEDULER
or pm) and day of week are entered correctly.
function must be set to
Mode: off/once/rpt. weekly
Check to make sure
C L O C K
l
Blank screen (no signal)
Maybe channel 91 or 92 is selected, but device connected to
l
those
jacks is not turned on.
INPUT
Try another channel.
l
Wrong antenna input
or
(A
l
(antenna) button on master remote. Details are on page 41.
function in
Cable/air
SETUP
l
changed. Details are on page 40.
No sound, picture okay
Maybe sound is muted. Try pressing
l
restore sound.
Maybe TV's speakers are turned off. Check
l
or
Int spkrs: on/off
menu for audio mode selected.
Can not select certain channel
Channel may not be in channel memory scan list. Try
l
pressing two number buttons.
function
Channels: normal/priority
l
Details are on page 42.
Channels: priority.
If using a VCR, check to make sure the
l
VCR is in the correct position.
To select channels 100 through 128, press and hold number
l
button "1" until "1--" appears on the TV screen, then press
the other two number buttons. The
menu must be set to
Cable
SETUP
than 69.
TV picture is fuzzy or details outlined by red,
green, or blue
Use the
function to realign the projection
CONVERGENCE
l
picture tube. Details are on page 5.
SCHEDULER
or
once
function is set correctly.
selected. Try pressing
B)
ANT
menu may have accidentally been
up button to
VOLUME
Speakers:
function on
AUDIO ADJUST SETUP
On MAIN MENU Set to
switch on the
function in the
Cable/air
to select channels higher
Advertisement
Table of Contents
