Table of Contents
Advertisement
Chapter 17 Zones
17.2 Zone Commands Summary
The following table describes the values required for many zone commands. Other values are
discussed with the corresponding commands.
Table 56 Input Values for Zone Commands
LABEL
profile_name
This table lists the zone commands.
Table 57 zone Commands
COMMAND
show zone [profile_name]
show zone binding-iface
show zone none-binding
show zone user-define
[no] zone profile_name
zone profile_name
[no] block
[no] interface interface_name Adds the specified interface to the specified zone. The
exit
122
DESCRIPTION
The name of a zone.
Use up to 31 characters (a-zA-Z0-9_-). The name cannot start with a number.
This value is case-sensitive.
DESCRIPTION
Displays information about the specified zone or about
all zones.
Displays each interface and zone mappings.
Displays the interfaces that are not associated with a
zone yet.
Displays all customized zones.
Creates the zone if necessary and enters sub-
command mode. The
Enter the sub-command mode.
Blocks intra-zone traffic. The
zone traffic.
no
specified zone.
Exits the sub-command mode for this zone.
command deletes the zone.
no
no
command removes the specified interface from the
NXC CLI Reference Guide
command allows intra-
Advertisement
Table of Contents
