Table of Contents
Advertisement
2.1.1 Debug Commands
Debug commands marked with an asterisk (*) are not available when the debug flag is on and
are for ZyXEL service personnel use only. The debug commands follow a syntax that is
Linux-based, so if there is a Linux equivalent, it is displayed in this chapter for your reference.
You must know a command listed here well before you use it. Otherwise, it may cause
undesired results.
Table 6 Debug Commands
COMMAND SYNTAX
debug alg
debug app
debug app show l7protocol
(*)
debug ca (*)
debug force-auth (*)
debug gui (*)
debug hardware (*)
debug interface
debug interface ifconfig
[interface]
debug ip dns
debug ip virtual-server
debug logging
debug manufacture
debug network arpignore (*) Enable/Display the ignoring of ARP
debug no registration
server (*)
debug policy-route (*)
debug service-register
debug show ipset
debug show registration-
server status
debug [cmdexec|corefile|ip
|kernel|mac-id-
rewrite|observer|switch
|system|zyinetpkt|zysh-ipt-
op] (*)
debug update server (*)
NXC CLI Reference Guide
DESCRIPTION
FTP/SIP ALG debug commands
Application patrol debug command
Shows app patrol protocol list
Certificate debug commands
Authentication policy debug commands
Web Configurator related debug
commands
Hardware debug commands
Interface debug commands
Shows system interfaces detail
DNS debug commands
Virtual Server (NAT) debug commands.
System logging debug commands
Manufacturing related debug
commands
responses for interfaces which don't
own the IP address
Set the myZyXEL.com registration/
update server to the official site
Policy route debug command
Service registration debug command
Lists the NXC's received cards
myZyXEL.com debug commands
ZLD internal debug commands
Update server debug command
Chapter 2 User and Privilege Modes
LINUX COMMAND EQUIVALENT
> cat /etc/l7_protocols/
protocol.list
> ifconfig [interface]
cat /proc/sys/net/ipv4/
conf/*/arp_ignore
33
Advertisement
Table of Contents
