Log Entries Commands; System Log Commands - ZyXEL Communications NXC Series Cli Reference Manual

Chapter 35 Logs

35.1.1 Log Entries Commands

This table lists the commands to look at log entries.
Table 118 logging Commands: Log Entries
COMMAND
show logging entries [priority pri] [category
module_name] [srcip ip] [dstip ip] [service
service_name] [begin <1..512> end <1..512>]
[keyword keyword]
show logging entries field field [begin
<1..512> end <1..512>]

35.1.2 System Log Commands

This table lists the commands for the system log settings.
Table 119 logging Commands: System Log Settings
COMMAND
show logging status system-log
logging system-log category module_name
{disable | level normal | level all}
[no] logging system-log suppression interval
<10..600>
[no] logging system-log suppression
[no] connectivity-check continuous-log
activate
show connectivity-check continuous-log status
clear logging system-log buffer
220
DESCRIPTION
Displays the selected entries in the system log.
PRI: alert | crit | debug | emerg | error | info | notice
| warn
keyword: You can use alphanumeric and
:=?!*#@$_%- characters, and it can be up to 63
characters long. This searches the message,
source, destination, and notes fields.
Displays the selected fields in the system log.
field: time | msg | src | dst | note | pri | cat | all
DESCRIPTION
Displays the current settings for the system log.
Specifies what kind of information, if any, is logged
in the system log and debugging log for the
specified category.
Sets the log consolidation interval for the system
log. The command sets the interval to ten.
no
Enables log consolidation in the system log. The
no command disables log consolidation in the
system log.
Has the NXC generate a log for each connectivity
check. The no command has the NXC only log the
first connectivity check.
Displays whether or not the NXC generates a log
for each connectivity check.
Clears the system log.
NXC CLI Reference Guide
()+/