Application Watchdog Commands Example - ZyXEL Communications NXC Series Cli Reference Manual

Table 136 app-watchdog Commands
COMMAND
[no] app-watch-dog mem-
threshold min <1..100> max
<1..100>
app-watch-dog reboot-log flush
[no] app-watch-dog retry-count
<1..5>
[no] app-watch-dog sys-reboot
show app-watch-dog config
show app-watch-dog monitor-list Displays the list of applications that the application watchdog is
show app-watch-dog reboot-log

41.3.1 Application Watchdog Commands Example

The following example displays the application watchdog configuration.
Router# configure terminal
Router(config)# show app-watch-dog config
Application Watch Dog Setting:
activate: yes
alert: yes
console print: always
retry count: 3
auto recover: yes
system reboot: yes
interval: 60 seconds
mem threshold: 80% ~ 90%
cpu threshold: 80% ~ 90%
disk threshold: 80% ~ 90%
Router(config)#
NXC CLI Reference Guide
DESCRIPTION
Sets the percentage thresholds for sending a memory usage alert. The
NXC starts sending alerts when memory usage exceeds the maximum
(the second threshold you enter). The NXC stops sending alerts when
the memory usage drops back below the minimum threshold (the first
threshold you enter). The no command changes the setting back to the
default.
Flushes the reboot log record.
Set how many times the NXC is to re-check a process before
considering it failed. The no command changes the setting back to the
default.
If auto recover fail reaches the maximum retry count, app-watch-dog
reboots the device. The no command turns off system auto reboot.
Displays the application watchdog timer settings.
monitoring.
Displays the application watchdog reboot log.
Chapter 41 Watchdog Timer
247