Table of Contents
Advertisement
Chapter 42 Managed AP Commands
42.3 CAPWAP Client Commands
Use the CAPWAP client commands to configure the AP's IP address and other related
management interface settings. Do not use the original interface commands to configure the IP
address and related settings on the AP, because the AP does not save interface command
settings after rebooting.
The following table identifies the values required for many of these commands. Other input
values are discussed with the corresponding commands.
Table 137 Input Values for CAPWAP Client Commands
LABEL
ip
netmask
gateway
primary_ac_ap
secondary_ac_ap
vid
primary_ac_dns
secondary_ac_dns
The following table describes commands for configuring the AP's CAPWAP client
parameters, which include the management interface. You must use the
terminal
Table 138 Command Summary: CAPWAP Client
COMMAND
capwap ap vlan ip address ip netmask
capwap ap vlan ip gateway gateway
capwap ap vlan no ip gateway
capwap ap vlan vlan-id vid { tag | untag } Sets the AP's management VLAN ID as well as whether
capwap ap ac-ip
{primary_ac_ip|primary_ac_dns}
{secondary_ac_ip|secondary_ac_dns}
capwap ap ac-ip auto
show capwap ap info
show capwap ap discovery-type
show capwap ap ac-ip
250
DESCRIPTION
IPv4 address.
The network subnet mask. For example, 255.255.255.0.
The default gateway IP address of the interface. Enter a standard IPv4 IP
address (for example, 127.0.0.1).
The primary IPv4 address of the NXC.
Optional IPv4 address of the NXC.
The VLAN ID (1~4094) of the managed AP.
The primary fully qualified domain name (FQDN) of the NXC.
The secondary fully qualified domain name (FQDN) of the NXC.
command to enter the configuration mode before you can use these commands.
DESCRIPTION
Sets the IP address and network mask of the AP's
management interface.
Sets the default gateway IP address for the AP's
management interface.
Clears the default gateway IP address setting for the AP's
management interface.
the AP sends tagged or untagged packets. The
management VLAN on the NXC and AP must match for
the NXC to manage the AP. The NXC's force vlan
command (see
Table 29 on page
this command.
Specifies the primary and secondary IP address or
domain name of the AP controller (the NXC) to which the
AP connects.
Sets the AP to use DHCP to get the address of the AP
controller (the NXC).
Displays the IP address of the NXC managing the AP and
CAPWAP settings and status.
Displays how the AP finds the NXC.
Displays the address of the NXC or auto if the AP finds
the NXC through broadcast packets.
configure
74) takes priority over
NXC CLI Reference Guide
Advertisement
Table of Contents
