Changing The Password; Cli Modes - ZyXEL Communications UAG Series Reference Manual

Chapter 1 Command Line Interface
• Enter
range

1.4.6 Changing the Password

It is highly recommended that you change the password for accessing the UAG. See
on page 225

1.5 CLI Modes

You run CLI commands in one of several modes.
Table 2 CLI Modes
What Guest users
can do
What User users
can do
What Limited-
Admin users can
do
What Admin
users can do
How you enter it
What the prompt
looks like
How you exit it
See Chapter 44 on page 224
look at (but not run) the available commands in User mode, and log out. Limited-Admin users
can look at the configuration in the web configurator and CLI, and they can run basic diagnostics in
the CLI. Admin users can configure the UAG in the web configurator or CLI.
At the time of writing, there is not much difference between User and Privilege mode for admin
users. This is reserved for future use.
30
exactly as it appears, followed by two numbers between 1 and 65535.
for the appropriate commands.
USER
Unable to access
• Look at (but not
run) available
commands
• Look at system
information (like
Status screen)
• Run basic
diagnostics
• Look at system
information (like
Status screen)
• Run basic
diagnostics
Log in to the UAG
Router>
Type exit
for more information about the user types. User users can only log in,
PRIVILEGE CONFIGURATION
Unable to access Unable to access
Unable to access Unable to access
• Look at system Unable to access
information (like
Status screen)
• Run basic
diagnostics
• Look at system • Configure simple
information (like features (such
Status screen) as an address
object)
• Run basic
diagnostics • Create or
remove complex
parts (such as
an interface)
Type enable in User Type configure
mode terminal in User or
Privilege mode
Router# Router(config)#
Type disable Type exit
Section 44.2
SUB-COMMAND
Unable to access
Unable to access
Unable to access
• Configure
complex parts
(such as an
interface) in the
UAG
Type the command
used to create the
specific part in
Configuration
mode
(varies by part)
Router(zone)#
Router(config-if-
ge)#
...
Type exit
UAG CLI Reference Guide