Route; Chapter 16 Route; Policy Route; Policy Route Commands - ZyXEL Communications UAG Series Reference Manual

This chapter shows you how to configure policies for IP routing and static routes on your UAG.

16.1 Policy Route

Traditionally, routing is based on the destination address only and the UAG takes the shortest path
to forward a packet. IP Policy Routing (IPPR) provides a mechanism to override the default routing
behavior and alter the packet forwarding based on the policy defined by the network administrator.
Policy-based routing is applied to incoming packets on a per interface basis, prior to the normal
routing.

16.2 Policy Route Commands

The following table identifies the values required for many of these commands. Other input values
are discussed with the corresponding commands.
Table 59 Input Values for General Policy Route Commands
LABEL
address_object
interface_name
policy_number
schedule_object
service_name
user_name
UAG CLI Reference Guide
C
DESCRIPTION
The name of the IP address (group) object. You may use 1-31 alphanumeric
characters, underscores( ), or dashes (-), but the first character cannot be a
_
number. This value is case-sensitive.
The name of the interface.
See Table 37 on page 86 for detailed information about the interface name.
The number of a policy route. 1 - X where X is the highest number of policy routes
the UAG model supports. See the UAG's User's Guide for details.
The name of the schedule. You may use 1-31 alphanumeric characters,
underscores( ), or dashes (-), but the first character cannot be a number. This value
_
is case-sensitive.
The name of the service (group). You may use 1-31 alphanumeric characters,
underscores( ), or dashes (-), but the first character cannot be a number. This value
_
is case-sensitive.
The name of a user (group). You may use 1-31 alphanumeric characters,
underscores( ), or dashes (-), but the first character cannot be a number. This value
_
is case-sensitive.
HAPTER
1 6

Route

114