ZyXEL Communications UAG Series Reference Manual page 88

Chapter 13 Interfaces
Table 38 interface General Commands: Basic Properties and IP Address Assignment (continued)
COMMAND
traffic-prioritize {tcp-ack|content-
filter|dns|ipsec-vpn|ssl-vpn}
deactivate
[no] upstream <0..1048576>
interface reset
{interface_name|virtual_interface_name|al
l}
interface send statistics interval
<15..3600>
show interface-name
interface-name {ppp_interface |
ethernet_interface} user_defined_name
interface-rename old_user_defined_name
new_user_defined_name
13.2.1.1 Basic Interface Properties Command Examples
The following commands make Ethernet interface wan1 a DHCP client.
Router# configure terminal
Router(config)# interface wan1
Router(config-if)# ip address dhcp
Router(config-if)# exit
88
DESCRIPTION
Turns off traffic priority settings for when the interface sends the
specified type of traffic.
Specifies the upstream bandwidth for the specified interface. The
command sets the upstream bandwidth to 1048576.
Resets the interface statistics TxPkts (transmitted packets) and RxPkts
(received packets) counts to 0. You can use the show interface
summary all status command to see the interface statistics.
Sets how often the UAG sends interface statistics to external servers.
For example, syslog server and Vantage Report server.
Displays all PPP and Ethernet interface system name and user-defined
name mappings.
Specifies a name for a PPP or an Ethernet interface. It can use
alphanumeric characters, hyphens, and underscores, and it can be up to
11 characters long.
ppp_interface | ethernet_interface: This must be the system name
of a PPP or an Ethernet interface. Use the show interface-name
command to see the system name of interfaces.
user_defined_name:
• This name cannot be one of the follows:
"ethernet", "ppp", "vlan", "bridge", "virtual", "status", "summary",
"all"
• This name cannot begin with one of the follows either:
"ppp", "vlan", "br".
Modifies the user-defined name of a PPP or an Ethernet interface.
no
UAG CLI Reference Guide