Dynamic-Guest Sub-Commands - ZyXEL Communications UAG Series Reference Manual

Chapter 55 Dynamic Guest Accounts
Table 169 dynamic-guest Commands (continued)
COMMAND
[no] dynamic-guest user_name
show dynamic-guest log
show dynamic-guest log create-time
begin yyyy-mm-dd hh:mm end yyyy-mm-dd
hh:mm
show dynamic-guest users

55.2.1 dynamic-guest Sub-commands

The following table describes the sub-commands for several dynamic-guest commands. Note that
not all rule commands use all the sub-commands listed here.
Table 170 dynamic-guest Sub-commands
COMMAND
bandwidth {upload | download}
<0..1048576> priority <1..7>
[no] bandwidth activate
charge price
create-time yyyy-mm-dd hh:mm
expire-time yyyy-mm-dd hh:mm
password password
payment-info {cash | payment-
service}
phone phone_number
quota {total | upload | download}
megabytes <0..1023>
quota {total | upload | download}
gigabytes <0..100>
quota type {total | upload-
download}
270
DESCRIPTION
Creates a dynamic guest account (billing-user) with the specified user
name and enters the dynamic-guest sub-command mode to set the
password and timeout settings. See
commands.
The no command removes the specified dynamic-guest account.
Displays all the dynamic guest accounts which are either active or expired.
Displays all the active and/or expired dynamic guest accounts that were
generated within a specified period of time.
Displays all the active dynamic guest accounts on the UAG.
DESCRIPTION
Specifies the maximum bandwidth allowed for the user account in kilobits
per second and types a number between 1 and 7 to set the priority for the
user's traffic. The smaller the number, the higher the priority.
upload refers to the traffic the UAG sends out from a user.
download refers to the traffic the UAG sends to a user.
Turns on bandwidth management for the user account.
The no command disables bandwidth management for the user account.
Sets the account's price, up to 99999999.99, per time unit.
Sets the date and time the account is created.
Sets the date and time the account becomes invalid.
Sets the password for the account.
Sets the method of payment for the account.
Sets the mobile phone number for the account.
Sets how much downstream and/or upstream data in Megabytes can be
transmitted through the external interface before the account expires. 0
means there is no data limit for the user account.
Sets how much downstream and/or upstream data in Gigabytes can be
transmitted through the external interface before the account expires. 0
means there is no data limit for the user account.
Sets a limit for the user account. This only applies to user's traffic that is
received or transmitted through the external interface.
Note: When the limit is exceeded, the user is not allowed to access the
Internet through the UAG.
total: set a limit on the total traffic in both directions.
upload-download: set a limit on the upstream traffic and downstream
traffic respectively.
Table 170 on page 270 for the sub-
UAG CLI Reference Guide