Zon Commands; Zon Examples - ZyXEL Communications UAG Series Reference Manual

Chapter 56 System

56.8.2 ZON Commands

The following table describes the commands available for ZON. You must use the
command to enter the configuration mode before you can use these commands.
terminal
Table 178 Command Summary: ZON
COMMAND
zon lldp server
zon lldp server tx-hold <1..10>
zon lldp server tx-interval <1..600>
zon zdp server
show zon lldp neighbors
show zon lldp server config
show zon lldp server statistics
show zon lldp server status
show zon zdp server status

56.8.3 ZON Examples

This example enables LLDP discovery and displays whether LLDP discovery is enabled on the UAG.
Router(config)# zon lldp server
Router(config)# zon lldp server status
status: active
Router(config)#
280
DESCRIPTION
Activates LLDP discovery on the UAG.
This allows you to use Link Layer Discovery Protocol (LLDP) for
discovering and configuring LLDP-aware devices in the same
broadcast domain as the UAG that you are logged into using the
web configurator.
Sets the multipler used to calculate the TTL (Time To Live) value
for the transmitted LLDP packets. The TTL value determines how
long the device information can be saved on the neighbors.
LLDP TTL = the multipler * the LLDP transmission interval
Sets the interval (in seconds) at which the UAG sends a LLDP
packet to the neighbor.
Activates ZDP discovery on the UAG.
Displays the the UAG's neighboring devices via LLDP.
Displays the LLDP settings.
Displays the LLDP traffic statistics.
Displays whether LLDP discovery is enabled.
Displays whether ZDP discovery is enabled.
configure
UAG CLI Reference Guide